Beams, sections & plates / Manufacturer enquiry
Jindal
Enquire about Jindal structural materials with the exact make and section specified.
What to know
A make-specific requirement deserves the details.
Jindal Steel's published range includes parallel-flange beams and columns, angles, channels, plates and hollow sections. More than one manufacturer uses the Jindal name. Include the exact manufacturer from your drawing, approved-vendor list or existing material marking so the quotation refers to the right make; we confirm it before order acceptance.
Include this in the enquiry
- Exact Jindal manufacturer or approved-make reference
- Section designation, weight per metre and lengths
- Required grade and mill test certificate requirements
Official product references
Jindal product information
These summaries follow the manufacturer’s public product information. Where a source publishes dimensions, we share range limits without inferring every size-and-thickness combination. Some sources identify product types only. Add the exact size from your drawing or specification to the enquiry.
- MS Beams & Structural Sections
NPB 180 × 90–600 × 220 mm; WPB 160 × 160–900 × 300 mm; UB and UC ranges vary by standard.
The structural brochure describes 49 beam/column sizes and 160 unit-weight variants. Share the exact series, section mark and kg/m from the approved drawing.
- MS Channels
ISMC 100 × 50 mm to 400 × 100 mm.
These are published end dimensions, not a complete list of every section and weight. Include the ISMC designation or drawing reference.
- MS Angles
Equal-leg ISA 75 × 75 mm to 250 × 250 mm.
The range does not state every leg-thickness combination. Type both legs and thickness, and state whether the angle is equal or unequal.
- MS Plates & Sheets
Discrete plates: 5–150 mm thick, 1,500–4,900 mm trimmed width, lengths up to 24 m.
Mill-edge width is listed up to 5,000 mm. Cut-to-length plates are listed at 6–25 mm thick, 1,500–2,500 mm wide and 6,000–12,500 mm long. Dimensions depend on product route and standard.
- Square & Rectangular Hollow Sections
SHS: 60 × 60–600 × 600 mm; RHS: 96 × 48–600 × 550 mm; CHS: 3–8 in outside diameter.
The brochure gives wall-thickness ranges by profile and grade. Its extracted chart does not reliably expose every marked size/thickness cell, so no unverified combinations are suggested.
Related material pages
Specify the actual section.
The manufacturer range is not a live stock list. Product pages explain what sizes and quantities help us check.
- Material enquiryMS Beams & Structural SectionsI-beams and heavier sections for load-bearing structures.Sizing notes
- Material enquiryMS AnglesL-section angles for frames, supports and brackets.Sizing notes
- Material enquiryMS ChannelsC/U sections for chassis, purlins and structural framing.Sizing notes
- Material enquiryMS Plates & SheetsFlat stock for base plates, gussets, covers and fabrication.Sizing notes
- Material enquirySquare & Rectangular Hollow SectionsSHS and RHS tubes for clean, strong modern frames.Sizing notes
Quotation checklist
A good start is enough.
You can add the rest in the enquiry notes. We’ll confirm specifics with you.
Exact Jindal manufacturer or approved-make reference
Section designation, weight per metre and lengths
Required grade and mill test certificate requirements
Keep comparing requirements