Everyday fabrication sections / Manufacturer enquiry
Ramsons
Angles, channels, beams, flats, bars and pipes for mixed material lists.
What to know
A make-specific requirement deserves the details.
Ramsons' published steel range includes MS angles, channels, I-beams, flats, round and square bars, and pipes. A mixed list is often the simplest way to quote a fabrication job: group items by profile, write every size on its own line and state whether quantities are lengths, pieces or kilograms. Brand-specific stock and freight are confirmed before an order.
Include this in the enquiry
- Profile, size and required length for each item
- Quantity with a clear unit for every line
- Any grade, certificate or delivery-date requirement
Official product references
Ramsons product information
These summaries follow the manufacturer’s public product information. Where a source publishes dimensions, we share range limits without inferring every size-and-thickness combination. Some sources identify product types only. Add the exact size from your drawing or specification to the enquiry.
- MS Angles
Angles from 17 × 17 mm to 75 × 75 mm, with varied thicknesses.
The official brochure does not list all leg/thickness combinations. It also describes Z sections and gate channels; send the drawing mark for those profiles.
Source: Ramsons Group product brochure
- MS Channels
MS channels from 75 mm to 100 mm.
The published range is by section size, not a full dimension/weight matrix. Include the channel designation, length and quantity.
Source: Ramsons Group product brochure
- MS Beams & Structural Sections
I-beams are listed in the product range; no complete public size table is provided.
Share the section designation or the exact dimensions and kg/m shown on the drawing.
Source: Ramsons Group product brochure
- MS Flats
Flat bars from 12 × 3 mm to 150 × 25 mm.
The size notation is width × thickness. Ramsons also describes custom lengths; state the required length and quantity.
Source: Ramsons MS Flats product page
- MS Round & Square Bars
Round bars: 6–25 mm diameter; square bars: 8–50 mm side.
The source publishes ranges rather than every discrete diameter or side length. Type the exact size and required length.
- MS Pipes
MS pipes from ¾ in to 2 in across different cross-sections.
The brochure does not enumerate all OD/wall combinations. State whether the size is nominal bore or outside diameter, plus wall thickness and length.
Source: Ramsons Group product brochure
Related material pages
Specify the actual section.
The manufacturer range is not a live stock list. Product pages explain what sizes and quantities help us check.
- Material enquiryMS AnglesL-section angles for frames, supports and brackets.Sizing notes
- Material enquiryMS ChannelsC/U sections for chassis, purlins and structural framing.Sizing notes
- Material enquiryMS Beams & Structural SectionsI-beams and heavier sections for load-bearing structures.Sizing notes
- Material enquiryMS FlatsFlat bars for strips, clamps, grills and fabrication details.Sizing notes
- Material enquiryMS Round & Square BarsSolid bars for shafts, pins, grills and machined parts.Sizing notes
- Material enquiryMS PipesRound tubes for railings, structures and general use.Sizing notes
Quotation checklist
A good start is enough.
You can add the rest in the enquiry notes. We’ll confirm specifics with you.
Profile, size and required length for each item
Quantity with a clear unit for every line
Any grade, certificate or delivery-date requirement
Keep comparing requirements